Lynx Studio Technology
home products news & events support how to buy company contact
Search
Support Center
Downloads
Contact Tech Support

Frequently Asked Questions
Aurora
LynxONE
LynxTWO/L22
Lynx AES16 / AES16e
Lynx LS-ADAT / LS-AES
LT-HD

Software Application Notes
Hardware Test Procedures
Connector Pin Outs
Other useful documents
Videos
Support Documents
Support Forum
User Manuals
Register Your Products
Buy Cables Now
Aurora
• Getting Started/Installation
• Troubleshooting
• Operation
• Compatibility


  • Unit will not turn on.
  • Clicking, popping or crackling noises in your audio:
  • Audio plays back at a faster or slower rate than expected.
  • No audio to analog outputs.
  • SynchroLock LED does not illuminate.
  • Output is too loud for my monitoring equipment.
  • The selected Sync Source is flashing, and the INT LED is illuminated.
  • The Sync Source LED is flashing alternately between INT and the selected Sync Source.
  • I’m only getting half as many channels of conversion as expected, and channels are not routed as I would expect.
  • The Aurora Remote Control Software will not open or opens but does not allow parameters to be changed.
  • The Aurora firmware updater fails, reporting "there in no connected Aurora".


Audio plays back at a faster or slower rate than expected.
This is usually the result of mismatched clock rates and/or multiple clock masters. For example, if you are playing back audio recorded at 44.1 kHz, but you have set the clock for 48 kHz, the audio will play back faster and at a higher pitch than expected. Make certain you have set only one device as clock master, and that the selected sample rate matches the audio source.

Home | Products | News & Events | Support | How To Buy | Company | Contact Us | Employment | Privacy

Lynx on Facebook   Support on Facebook 		© Copyright 2025, Lynx Studio Technology, Inc.